Remote Control Operations - LG LA120CPI Service Manual

Operation

Remote Control Operations

The controls will look like the following.
Controls
5
6
4
2
7
ON OFF
11 AUTO CLEAN
8
13
15
Operation Mode
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
44 Room Air Conditioner
1. START/STOP BUTTON
2. OPERATION MODE SELECTION BUTTON
Signal transmitter
3. ROOM TEMPERATURE SETTING BUTTONS
4. INDOOR FAN SPEED SELECTOR
5. JET COOL/HEATING(OPTIONAL)
1
6. CHAOS SWING BUTTON
3
7. ON/OFF TIMER BUTTONS
10
CANCEL
9
8. TIME SETTING BUTTONS
SET
12
17
9. TIMER SET/CANCEL BUTTON
C/ F
18
14
16
10. SLEEP MODE AUTO BUTTON
11. AIR CIRCULATION BUTTON
Flip-up door
12. ROOM TEMPERATURE CHECKING BUTTON
(opened)
13. NEO PLASMA(OPTIONAL)
14. HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON
15. RESET BUTTON
16. 2nd F Button
17. AUTO CLEAN (OPTIONAL)
)
18. °C/°F SWITCH BUTTON
Operation starts when this button is pressed and stops when
the button is pressed again.
Used to select the operation mode.
Used to select the room temperature.
Used to select fan speed in four steps low, medium,
high and CHAOS.
Used to start or stop the speed cooling/heaing.
(speed cooling/heating operates super high fan speed in
cooling/heatig mode.)
Used to stop or start louver movement and set the
desired up/down airflow direction.
Used to set the time of starting and stopping operation.
Used to adjust the time.
Used to set the timer when the desired time is obtained and to cancel
the Timer operation.
Used to set Sleep Mode Auto operation.
Used to circulate the room air without cooling or heating.
Used to check the room temperature.
Used to start or stop the plasma-purification function.
(OPTIONAL)
Used to set the desired vertical airflow direction.
Used prior to resetting time.
Used prior to using modes printed in blue at the bottom of buttons.
Used to set Auto Clean mode.
Used to switch temperature reading from Centigrade to Fahrenheit.