System Maintenance, Continued; Adding Remote Controls; Basic Troubleshooting - Guardian CPL 100 Owner's Manual

System Maintenance, Continued

Adding Remote Controls to Your System
The CPL Security System has the ability to operate from up to 4 remote controls. Follow these steps to add
a remote control to your system.
1. Make sure the system is disarmed and the ignition is off.
2. Turn the ignition on.
3. Press and hold the override button. After 10 seconds the system will chirp 3 times indicating the
system has entered programming mode.
4. Release the button.
5. Press the LOCK button on the remote to be programmed. The horn will sound once, indicating that
the system has learned the remote.
6. Repeat step 5 for any addition remote controls.
7. Turn the ignition off to exit the programming mode.
Deleting Lost or Stolen Remote Controls from Your System
If one of your remote controls is lost or stolen, follow these steps to remove it from your system:
1. Have all of the remaining remotes available
2. Enter the remote control programming mode by following steps 1-4 from Adding Remote Controls
to Your System shown above.
3a. If you only have 1 remaining remote, press the LOCK button 4 times, pausing for one second
between each press. The horn must honk each time you press the button.
3b. If you have 2 remaining remotes, press the LOCK button on each remote 2 times, pausing for
one second between each press. The horn must honk each time you press the button.
3c. If you have 3 remaining remotes, press the LOCK button on the first remote 2 times and 1 time
on the following 2 remotes, pausing for one second between each press. The horn must honk each
time you press the button.
4. Turn the ignition off to exit the programming mode. The lost or stolen remote will no longer operate
the system.
Basic Trouble Shooting
Symptom
Remote does not work:
System will not arm:
Problem
Weak or dead battery.
Remote not programmed.
Door or entrance is open.
Courtesy light is on.
System is in Valet mode.
Solution
Change battery.
Program remote.
Close entrance.
Turn courtesy light off.
Exit Valet mode.
7