When Your Security System is Triggered, Continued
Attempted Intrusion Identification
Pressing UNLOCK after a full 30 second trigger cycle has completed, the horn will honk 4 times and the
LED will flash a number of times to indicate which input triggered the alarm. Turning on the ignition or
pressing the valet/override button will reset the LED flashes, pressing the valet/override button will also
honk the horn to match the LED flashes before it resets.
Number of flashes:
1 - Interior Theft Sensor (Shock Sensor)
2 - Door Input
4 - Hood/Trunk input
5 - Ignition
Emergency Disarm Procedure
If your remote control is lost or fails to function, use this procedure to disarm the CPL Security System and
start your vehicle.
1 - Use the keys to enter the vehicle. The alarm will sound once the door is opened.
2 - Insert the key into the ignition and turn to the ON position.
3 - Locate and press the emergency override button. The alarm will turn off and then you will be able
to start the vehicle.
System Maintenance
Changing the Remote Control Battery
The 3 volt lithium battery (model CR2032) inside each remote control should last approximately 1 year
under normal use. When the battery becomes weak you will notice the remote control range (the distance
from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim.
To replace the remote control batteries:
2.
Gently unsnap the halves of the remote control apart using a small flat head screw driver.
3.
Unsnap the lithium battery out of the circuit board, observing the +/- symbols on the battery
and replace with a new lithium 3 volt battery (model CR2032)
4.
Gently snap the halves of the remote control back together.
5.
Test operation of the remote control.
6
Your Emergency Override Button is Located:
_________________________________________