Mechanical Disassembly - Sanyo PLC-XC50 Service Manual

Mechanical Disassembly

Mechanical disassembly should be made following procedures in numerical or-
der.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original
otherwise it may cause loss of performance and product safety.
z Cabinet Top, Lamp Cover, Filter Cover and Lens Cover removal
1. Remove 8 screws A (M3X8) to remove the Cabinet Top.
2. Loosen Screw B (M3X7) to remove the Lamp Cover.
3. Loosen 2 Screws B (M3X7) to remove the Filter Cover.
4. Remove the Control Buttons.
5. Remove the Front Glass and the Front Ring.
6. Remove 2 Screws C (T3X6) to remove the Holder of Front Glass. Remove 2 Screws D
(T3X6) to remove the Holder of Lens Shutter.
Turn the Front Ring anticlockwise and
remove the Front Glass.
Holder of Front Glass
B(M3x7)x2
A(M3x8)x8
Control Buttons
Front Glass
Front Ring
Holder of Lens
Shutter
Filter Cover
A
Lens Shutter
C
C(T3x6)x2
D
D(T3x6)x2
A
A
-13-
Screws Expression
(Type
Diameter x Length
T type
Lamp Cover
B(M3x7)x1
Cabinet top
A
A
A
A
) mm
M Type
Fig.1