Dyna-Glo DGF510SSP User Manual page 14

ASSEMBLY INSTRUCTIONS
14. First, remove the side burner and keep the 2
screws that were removed. Secure side burner
valve assembly and Side burner control knob
bezel (M) to Right side burner table assembly
(L) with 2 M4X10 screws (DD), then install the
side burner to Right side burner table assembly
(L) with the 2 screws removed previously. Make
sure the side burner orifice is placed into the
gas inlet tube of side burner. Install the ignition
wire to side burner electrode, place the Side
burner cooking grate (K) on the Right side
burner table assembly (L).
Hardware Used
M4x10 Screw
DD
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 15.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
Wrong
Wrong
Correct
14
x 2
DD
14
K
Side
Burner
Ignition
Wire
Side
Burner
M