Page 1
Installation and Operating Instructions Focal Point Fire with Optiflame® Elite incorporating 2kW Fan Heater AUS/NZ Model: Auvergne Log Model 2920. Issue 2. 5/01/04 08/18720/0 IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Introduction This fire incorporates a flame effect which can be used without heating, so that the comforting effect may be enjoyed at any time of the year.
Page 2
Preparation for use WARNING: THIS APPLIANCE MUST BE EARTHED This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage. Important Safety Advice: When using electrical appliances, Basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: •...
Page 3
Operation The controls are located behind the hinged ash pan flap (see Fig.3). A switch is in the ‘ON' position when the red indicator mark of the switch is visible. Connect the fire to your electricity supply. Flame Effect Press switch to the 'ON' position.
Page 4
Maintenance WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE. Lamp replacement To gain access to the lamps, open the firebox door, remove the two screws securing the fuel effect assembly (see Fig.5). Slide out the fuel effect assembly. (See Fig. 5). Carefully rotate the lamp anti-clockwise until it comes out of its holder (see Fig.