Standard Installation For Flat Cabinets - Black & Decker Spacemaker SCM1000BD Use & Care Manual

STANDARD INSTALLATION FOR FLAT CABINETS ONLY
Important: Always wear protective glasses or goggles to prevent injury
when drilling.
Important: Do not align screw holes on the template directly under the
partition between cabinets, as this will prevent you from installing the
appliance properly. Pay close attention to where drill holes will be set so as
not to damage your cabinets during mounting. Drilling through your cabinet's
partition may cause damage to cabinets and prevent proper installation.
1. Clear countertop under installation area to avoid getting dust or
debris on other appliances or items. Open cabinets and remove
contents to make mounting easier.
2. Clean both the underside and topside of the bottom panel of the
cabinet.
3. Decide whether you will be drilling from the top down or from the
bottom up.
IF DRILLING FROM THE BOTTOM UP: With cabinet doors open,
4.
place mounting template against the
surface of the front edge of your cabinet.
Align the thick line on the template
(labeled "front edge of cabinet") with the
lower front edge of your cabinet (D).
5. Fold the balance of the template up
along the underside of your cabinet,
ensuring the "front edge of cabinet" line
remains aligned with the bottom front
cabinet edge.
6. Make sure the template is smooth and
fl ush against the cabinet's underside.
Pull template tight and tape down to
hold in place.
7. IF DRILLING FROM THE TOP DOWN:
With cabinet doors open, place mounting
template against the surface of the front
edge of your cabinet. Align the thick line
on the template (labeled "front edge of
cabinet") with the upper front edge of
your cabinet (E).
8. Fold the balance of the template over
into the inside of your cabinet, ensuring
the "front edge of cabinet" line remains
aligned with the upper front cabinet
edge.
9. Make sure the template is smooth and
fl ush against the cabinet's inside. Pull
template tight and tape down to hold in
place.
D
E
8