Table of Contents
Advertisement
INSTALLATION
PANEL INSTALLATION
1.
Unload inner frame: Slide the knob, release the buckle from the outside frame hole, then unload the inner frame (Chart 9)
2.
Hang the outside frame on the main body with face down . (4 places at 4 corners): Hang the belt on the hook of the main body .
(Charts 0 & )
Note: The signal wire of the remote control receiver must be drawn out through the canvas air passage .
3.
Fix the outside frame and the canvas air passage with screws: screw must be fixed on from the bottom to the top (Chart 12)
4.
Hang up the outside frame until it sticks to the ceiling tightly . (Chart 3)
5.
Fix the main body and the outside frame with the fix board of waist-shape hole (in two places) (Chart 14):
•
Hang one side of the fix board of the waist-shaped hole on the hook of the main body.
•
Tighten the other side of the board with screw to the outside frame .
•
Cut off the surplus part of the board with pliers .
•
Bend the top of the broken end .
Note: when hanging up the outside frame with the fix board of waist-shaped hole and the belt, stick the outside frame tightly to
the ceiling and fix it.
6.
Install the inner frame on the outside frame (the inverse sequence of unloading the inner frame) (Chart 4)
Note: Connect the remote control receiver with the indoor unit signal wires and fix it.
7.
Install remote controller .
Inside frame
Buckle
Outside frame
Chart 9
Screw
Chart 2
Hook
Waist-shaped hole
fixed board
Outside frame
Chart 4
DUCTAIR II - 0808-E
Knob
Ceiling
Canvas air passage
Ceiling
Bend
Main body
Canvas air passage
Waist-shaped hole
fixed board
Outside frame
Chart 0
Ceiling
Inside frame
Hook
Air passage
Chart
Main body
Canvas air passage
Outside frame
Chart 3
(Reverse side)
Outside frame
Air inlet
Chart 5
Gallus
Outside
frame
• 7 •
Advertisement
Table of Contents
