Lexmark C734DN Wireless Setup Manual page 20

3
Set the COM port parameters:
After the printer driver is installed, you must set the serial parameters in the communications (COM) port assigned
to the printer driver.
The serial parameters in the COM port must match the serial parameters you set in the printer.
a
Open the Device Manager. Do one of the following:
In Windows Vista
1
Click .
2
Click Control Panel.
3
Click System and Maintenance.
4
Click System.
5
Click Device Manager.
In Windows XP
1
Click Start.
2
Click Control Panel.
3
Click Performance and Maintenance.
4
Click System.
5
From the Hardware tab, click Device Manager.
In Windows 2000
1
Click Start.
2
Click Settings
3
Click System.
4
From the Hardware tab, click Device Manager.
b
Click + to expand the list of available ports.
c
Select the communications port where you attached the serial cable to your computer (example: COM1).
d
Click Properties.
e
On the Port Settings tab, set the serial parameters to the same serial parameters in the printer.
Look for the printer settings under the serial heading on the Menu Settings page you printed earlier.
f
Click OK, and then close all the windows.
g
Print a test page to verify printer installation. When a test page prints successfully, printer setup is complete.
Control Panel.
Connecting to a wireless network using Macintosh
20