Product Diagram - Oster OGZF1301 User Manual

GROUNDING INSTRUCTIONS (continued)
ELECTRICAL REQUIREMENTS

The electrical requirements for this microwave are: 120V, 60Hz, AC only, 20 amp.

It is recommended that a separate circuit serving only the microwave be provided.

The microwave is equipped with a 3-prong grounding plug. It must be plugged into a wall outlet properly installed
and grounded.
POWER CORD

A short power supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a
long cord.

Longer cord sets or extension cords are available and may be used if care is taken in using them.

If using a longer cord, the marked electrical rating of the cord set or extension cord should be at least as great as
the electrical marking of the microwave itself and the extension cord must be a grounded-type 3-wire cord. The
longer cord should be arranged so it will not drape over the counter or tabletop.

If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service
person.

Neither the manufacturer nor the dealer can accept any liability for damage to the oven or personal injury
resulting from failure to observe the electrical connection procedures.
RADIO OR TV INTERFERENCE

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave
oven is on a different circuit, relocated the radio or TV as far away from the oven as feasible or check position
and signal of receiving antenna.

PRODUCT DIAGRAM

1. Door Lock System
2. Oven Window
3. Roller Ring
4. Shaft
5. Control Panel
Wave Guide (Do not remove)
6.
7. Glass Tray
5