Intended Use; Air Supply And Operation - Ryobi RA-NF90-K Operator's Manual

NOISE AND VIBRATION
Noise according to EN 12549:1999 and EN ISO 4871
A-weighted sound
L PA
pressure level
Sound power level L WA
A-weighted sound
pressure level(at L PA
C-weighted sound L PC,peak
pressure level K PC,peak =2.5 dB
Vibration according to ISO 8662-11:1999
ah,W=13.4 m/s 2 ,
Vibration in the
K=1.5 m/s 2
handle

INTENDED USE

The tool can be used for the purposes listed below:
Framing
Structural plywood
Decking
Fencing

AIR SUPPLY AND OPERATION

before connecting to the air supply.
Required air pressure range of 5.5 - 8.3 bar (80 - 120
Disconnect the product from the compressed air supply
before changing accessories or making adjustments.
Connect the product to the air hose.
Push the tool against the work surface and squeeze
the trigger to drive a fastener.
Do not use any additional force upon the product.
Ensure the air supply is clean and does not exceed
high an air pressure and unclean air will shorten the
product's life due to excessive wear, and may be
dangerous causing damage and/or personal injury.
ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
PA =2.5 dB
WA =2.5 dB
PA =2.5 dB
WARNING
Carefully remove the tool and any accessories from
the box. Make sure that all items listed in the packing
list are included.
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
could result in serious personal injury.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
Packing list
– Nailer
– Wrench kit
– Air tool oil
– Screw hanger
– Moulded carry case
– Operator's manual
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
in a hazardous condition leading to possible serious
personal injury.
OPERATION
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
4
WARNING
WARNING
WARNING
WARNING
WARNING