Residual Risks; Specifications - Ryobi RA-NF90-K Operator's Manual

against a work piece, These tools are marked with an
inverted triangle
not permitted for use without an effective safety yoke.
A safety yoke is not required on fastener driving tools
which accelerate the heaviest usable fasteners to a
free flight velocity below an admissible risk of injury.
Those fastener driving tools are not marked with an
inverted triangle.
SAFETY INSTRUCTIONS FOR COMPRESSED AIR
SYSTEM
Proper functioning of the fastener driving tool requires
filtered, dry and lubricated compressed air in adequate
quantities.
If the air pressure in the line system exceeds the
maximum allowable pressure of the fastener driving
tool, a pressure reducing valve followed by a
downstream safety valve shall additionally be fitted in
the supply line to the tool.
The compressor
dimensioned in terms of pressure output and
which is to be expected. Line sections which are too
small in relation to the length of the line (pipes and
result in pressure drops.
Permanently laid compressed air pipelines should
have an internal diameter of at least 19 mm and a
corresponding large diameter where relatively long
pipelines or multiple users are involved.
Compressed air pipelines should be laid so as to
form a gradient (highest point in the direction to the
should be installed at the lowest points.
Junctions for users should be joined to the pipelines
from above,
Connecting points for fastener driving tools should be
fitted with a compressed air servicing unit (filter/water

RESIDUAL RISKS

Even if you are operating this product in accordance
with all the safety requirements, potential risks of injury
and damage remain. The following dangers can arise in
connection with the structure and design of this product:
1. Health defects resulting from vibration and noise
emission if the product is being used over long periods
of time or not adequately managed and properly
maintained.
2. Injuries and damage to property due to fasteners or
the sudden impact of hidden objects during use.
3. Danger of injury and property damage caused by
behind the serial number and are
plant shall be adequately
SYMBOLS
Safety alert
CE conformity
Please read the instructions carefully before
starting the product.
Wear eye protection.
Wear ear protection.
Lubricate with air tool oil daily.
Keep hands away
Tacker with safety yoke

SPECIFICATIONS

FASTENER
Nail type
TOOL
Magazine capacity
Air inlet size
Air hose size
Air consumption
Working pressure
range
Exhaust
Tool weight
3
Clipped head framing
nails
2.87 – 3.33 mm
Nail range: 50 - 90 mm
Collation angle: 34°
70 nails
3.78 kg