Extension Cable Connection - Raymarine Dragonfly-4 Installation And Operation Instructions Manual

Note:
• The suitable fuse rating for the thermal breaker
is dependent on the number of devices you are
connecting. If in doubt consult an authorized
Raymarine dealer.
• Your product's power cable may have fitted
in-line fuse, if not then you can add an in-line
fuse to the positive wire of your products power
connection.
40

5.5 Extension cable connection

An optional extension cable can be used to extend
the distance from the transducer to the unit by up
to 4 m (13.1 ft).
1
1. Existing cable.
2. Extension cable (connected to the vessel's
power supply and to the existing cable.
3. Isolated power supply wires on existing
transducer cable.
Note:
• Only 1 extension cable should be used per
installation.
• The length of the power supply wires on the
extension cable is 2 m (6.6 ft).
Maximum transducer cable length
The maximum cable length from the transducer to
the unit is shown below.
CPT-DV
CPT-DVS
Note: Extending the transducer cable further than
the maximum stated distance will cause poor
performance.
2
3
12 V dc
D13241-1
8 m (26.2 ft.) — 4 m (13.1 ft.)
supplied cable + 4 m (13.1 ft.)
extension cable
10 m (32.8 ft.) — 6 m (19.7
ft.) supplied cable + 4 m (13.1
ft.) extension cable
Dragonfly-4 / Dragonfly-5 / WiFish