Connecting The Cable - Dv, Dvs, Pro And Wi-Fish Tm; Connecting The Power Cable - 5 M - Raymarine Dragonfly-4 Installation And Operation Instructions Manual

5.3 Connecting the cable - DV, DVS,
Pro and Wi-Fish TM
The unit has a combined power and transducer
cable that is attached to the transducer.
1. Connect the transducer / power connector to
the rear of the unit and secure using the locking
collar.
2. The drain wire should be connected to the vessel
RF ground point. If your vessel has no ground
point connect to the negative side of the vessel's
power supply.
3. The Negative wire must be connected to the
negative side of the 12 V dc power supply.
4. A fuse holder (not supplied) MUST be fitted to the
positive wire using a 5 A inline fuse.
5. The positive wire must be connected to the
positive side of the 12 V dc power supply.
38
1
12 V dc
D13190-1

5.4 Connecting the power cable - 5 M

1. Connect the power cable to the rear of the display
and secure using the locking collar.
2. The drain wire should be connected to the vessel
RF ground point. If your vessel has no ground
point connect to the negative side of the vessel's
power supply.
3. The Negative wire must be connected to the
negative side of the 12 V dc power supply.
4. A fuse holder and 5 A inline fuse (not supplied)
MUST be fitted to the positive wire.
5. The positive wire must be connected to the
positive side of the 12 V dc power supply.
Connecting the cable to the display
1. Unlocked
2. Locked
1. Ensure the locking collar is in the unlocked
position.
2. Ensure that the cable connector is orientated
so that the notch lines up with the guide in the
connector.
3. Push the cable connector all the way into the
display connector.
4. Rotate the locking collar clockwise until in the
locked position (2 clicks).
Warning: 12 Volt dc only
This product must only be connected to a
12 volt dc power source.
1
12 V dc
D13193-1
1
Dragonfly-4 / Dragonfly-5 / WiFish
D12779-2