Program Change Messages - Lexicon MPX G2 User Manual

Reception of MIDI Program Change and Bank Select messages can be
selectively enabled/disabled from the System mode MIDI menu. The manner
in which the MPX G2 interprets these messages is determined by the value of
this parameter as follows:
Pgm Change: Off
All Program Change and Bank select messages are ignored. Pgm+ and Pgm–
controllers will load the next higher or lower program in the current bank.
Pgm Change : On
Program Change messages 0-99 are recognized. Program Change messages
100—127 are ignored except when MIDI maps or chains are active.
Pressing Options from the Pgm Change display allows you to select a Pgm#
Offset (to allow matching of MPX1 program numbers to another MIDI device) or
to map Pgm+ and Pgm– controls to load the next higher or lower program in the
current bank.
Controller 32 is used to select Banks.
Program memory is organized into three banks as follows:
Program Bank 1
Program Bank 2
Program Bank 3
Three 128 element MIDI maps are stored internally. Program Change 0-127 can
be mapped to any MPX G2 program. When first shipped, the MPX G2 has each
map load with the following defaults:
Pgm+ and Pgm– will load the next higher or lower program in the map.
Any Program Change number can be selected to load any one of ten customized
effect "chains." Once a chain is loaded, effects in the chain are accessed by the
controller patched to Pgm + and Pgm – (program increment and program
decrement).
Preset programs 1-100
Preset programs 101-200
User programs 201-250
Map 1, 2 or 3
MIDI 1 = Program 1
MIDI 128 = Program 128
MIDI Operation
Program Change
Messages
6-5