Table of Contents
Advertisement
3-30
Instruments and controls/Light control switch
High/low beam change (dim-
mer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light
on the combina-
tion meter also illuminates.
To switch back to low beam, pull the lever
back to the center position.
Headlight flasher
To flash the headlights, pull the lever
toward you and then release it. The high
beam will remain on for as long as you
hold the lever. The headlight flasher works
even though the light switch is in the
OFF position.
When the headlights are on high beam,
the high beam indicator light
combination meter also illuminates.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
Daytime running light system
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the
is dark outside.
The high beam headlights will automati-
cally illuminate at reduced brightness
when the engine has started, under the
following conditions:
. The parking brake is fully released.
. The light switch is in the OFF or
position.
NOTE
When the light switch is in the
position, the front side marker lights,
on the
tail lights and license plate lights are
illuminated.
position when it
Advertisement
Chapters
Table of Contents
