Steering Wheel; Install Operator’s Seat; Adjusting The Seat - Cub Cadet RZT S Series Operator's Manual

Steering Wheel

1. Remove the hardware for attaching the steering wheel
from beneath the steering wheel cap. Carefully pry off the
steering wheel cap to remove the hardware.
2. With the wheels of the tractor pointing straight forward,
place the steering wheel over the steering shaft.
3. Place the belleville washer over the steering wheel and
secure with the hex screw. See Figure 3-3.
Steering Wheel Cap
Hex Screw
Steering Wheel
Column
4. Place the steering wheel cap over the center of the steering
wheel and push downward until it "clicks" into place.
Install Operator's Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan
attached. A second person may be needed to hold the seat.
1. Cut any straps securing the seat assembly to the tractor.
Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting the
seat and the seat switch in the bottom of the seat.
2. Remove the two shoulder bolts and flange locknuts in the
seat pan as shown in Figure 3-4.
3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder bolts and flange
locknuts. Be careful not to crimp or damage the wire
harness while installing the seat. See Figure 3-5.
NOTE: Be sure to push the excess wire from the wire harness into
the seat box hole before continuing.

Adjusting the Seat

To adjust the position of the seat, lift the seat adjustment lever
up. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked into
position before operating the tractor. See Figure 3-6.
10 S 3— A
ection SSembly
Belleville Washer
Figure 3-3
& S -U
et p
Shoulder Screws
Flange Lock Nuts
Figure 3-4
Shoulder Screws
Flange Lock Nuts
Figure 3-5
Figure 3-6