Declaration Of Conformity - Lexicon Reverb/Effects Processor PCM96 Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

DecLaratIon of conforMIty

manufacturer's Name:
manufacturer's Address:
declares that the product:
product name:
Note: product name may be suffixed by the eu.
product option:
conforms to the following product specifications:
safety:
emc:
supplementary information:
the product herewith complies with the requirements of the Low Voltage directive 73/23/eec
and the emc directive 89/336/eec as amended by directive 93/68/eec.
director of Lexicon engineering
8760 s. sandy parkway
sandy, utah 84070, usA
date: october 15, 2007
european contact: Your local Lexicon sales and service office or
harman music Group
8760 south sandy parkway
sandy, utah 84070, usA
ph: (801) 566-8800
Fax: (801) 566-7005
eLectroMaGnetIc
coMPatIBILIty
this unit conforms to the product specifications noted
on the Declaration of Conformity. operation is
subject to the following two conditions:
• this device may not cause harmful
interference, and
• this device must accept any interference received,
including interference that may cause undesired
operation.
operation of this unit within significant
electromagnetic fields should be avoided.
• use only shielded interconnecting cables.
If you want to dispose this product, do not mix it with general household waste. There is a
separate collection system for used electronic products in accordance with legislation that
requires proper treatment, recovery and recycling.
Private household in the 25 member states of the EU, in Switzerland and Norway may return their used
electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar
new one).
For Countries not mentioned above, please contact your local authorities for a correct method of disposal.
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and
recycling and thus prevent potential negative effects on the environment and human health.
Lexicon
®
8760 s. sandy parkway
sandy, utah 84070, usA
pcm96
None
iec 60065 (7th ed. 2001)
eN 55013 (2001+A1)
eN 55020 (1998)
U.K. MAINS PLUG WARNING
A molded mains plug that has been cut off
from the cord us unsafe. discard the mains plug
at a suitable disposal facility. NeVer uNder
ANY circumstANces shouLd You iNsert A
dAmAGed or cut mAiNs pLuG iNto A 13 Amp
poWer socKet. do not use the mains plug
without the fuse cover in place. replaceent fuse
covers can be obtained from your local retailer.
replacement fuses are 13 amps and must be
AstA approved to Bs1362.