Quick Start; Access The Web Interface (Wbm) - Siemens Asterisk OpenStage 20 Owner's Manual

2.3

Quick Start

This section describes a typical case: the setup of an OpenStage endpoint in an environment
using a DHCP server and the web interface. For different scenarios, cross-references to the
corresponding section of the administration chapter are given.
Alternatively, the DLS (Deployment Service) administration tool can be used. Its
>
Plug & Play functionality allows to provide the phone with configuration data by as-
signing an existing data profile to the phone's MAC address or E.164 number. For
further information, see the Deployment Service Administration Manual.
Any settings made by a DHCP server are not configurable by other configuration
>
tools.
2.3.1

Access the Web Interface (WBM)

1. Open your web browser and enter the transfer protocol, IP address and port number of
your phone. If HTTP is used, port 8085 must be added, for example
http://192.168.1.15:8085. For HTTPS, the phone uses the standard port 443.
After entering the URL, the browser might display a certificate notification. The start page
of the web interface appears. In the upper right corner, the phone number, the phone's IP
address, as well as the DNS name assigned to the phone are displayed. The left corner
contains the user menu tree.
A31003-S2000-M102-1-76A9, 06/02/2009
Asterisk - OpenStage Family, Administration Manual
inbetriebnahme.fm
Startup
Quick Start
2-7