To Adjust The Zone Setting; Integrated Home Linkwireless Control System - Hyundai Genesis Coupe Owner's Manual

Features of your vehicle

To adjust the Zone setting:

1. Determine the desired Zone Number
based upon your current location on
the Zone Map.
2. Press and hold the button for more
than 3 but less than 6 seconds, the
current Zone Number will appear on
the display.
3. Pressing and holding the
again will cause the numbers to incre-
ment (Note: they will repeat ...13, 14,
15, 1, 2, ...). Releasing the button
when the desired Zone Number
appears on the display will set the new
Zone.
4. Within about 5 seconds the compass
will start displaying a compass head-
ing again.
There are some conditions that can
cause changes to the vehicle magnets,
such as installing a ski rack or a CB
antenna. Body repair work on the vehicle
can also cause changes to the vehicle's
magnetic field. In these situations, the
compass will need to be re-calibrated to
quickly correct for these changes. To re-
calibrate the compass:
4 36
1. Press and hold the
than 6 seconds. When the compass
memory is cleared a "C" will appear in
the display.
2. To calibrate the compass, drive the
vehicle in 2 complete circles at less
than 5 mph (8 km/h).
button
Integrated HomeLink
System
The HomeLink®
System provides a convenient way to
replace up to three hand-held radio-fre-
quency (RF) transmitters with a single
built-in device. This innovative feature will
learn the radio frequency codes of most
current transmitters to operate devices
such as gate operators, garage door
openers, entry door locks, security sys-
tems, even home lighting. Both standard
and rolling code-equipped transmitters
can be programmed by following the out-
lined procedures. Additional HomeLink
information can be found at: www.home-
link.com or by calling 1-800-355-3515.
button for more
Before programming HomeLink
a garage door opener or gate oper-
ator, make sure that people and
objects are out of the way of the
device to prevent potential harm or
damage. Do not use HomeLink
with any garage door opener that
Wireless Control
®
lacks the safety stop and reverse
features required by U.S. federal
Wireless Control
safety standards (this includes any
garage door opener model manu-
factured before April 1, 1982). A
garage door that cannot detect an
object - signaling the door to stop
and reverse - does not meet current
U.S. federal safety standards. Using
a garage door opener without these
features increases the risk of seri-
ous injury or death.
Retain the original transmitter of the RF
®
device you are programming for use in
other vehicles as well as for future
HomeLink
gested that upon the sale of the vehicle,
the programmed HomeLink
erased for security purposes.
CAUTION
® programming. It is also sug-
® buttons be
® to
®