Table of Contents
Advertisement
21
21 AUX / DFX SENDS Connectors
These 1/4" phone jacks are used to send out the signal from the AUX bus to external
devices such as effect units and/or stage monitors.
22 P. AMP INPUT Jacks
These 1/4" phone jacks are used to input line level stereo signals to the built-in
power amplifier.
23 ST OUT Jacks
These jacks are used to output the signal of the STEREO bus. The final output
level from these jacks is adjusted by the ST OUT fader.
24 ST SUB IN 1 & 2 Jacks
These 1/4" jacks are used to connect stereo output of a sub mixer or external effect
processor. The signal input can be routed to the AUX1 & 2 bus and STEREO bus.
25 ST SUB OUT Jacks
These jacks are used to output the signal of the STEREO bus. Use the ST SUB
OUT control to adjust the final output level at the ST SUB OUT jacks. Generally,
it is available to connecting effects unit.
26 MONO OUTPUT Jack
Use this balanced MONO jack to connect the input of an external amplifier or
active monitor speaker.
27 FOOTSWITCH Jack
This 1/4" jack can be used to connect an external foot switch to turn on/off the
onboard effect module.
4. CONTROL ELEMENTS
22
1
1
AUX SEND
AUX SEND
P. AMP INPUT
P. AMP INPUT
C
2
2
AUX SEND
AUX SEND
D
DFX1 SEND
DFX1 SEND
1
1
ST SUB IN
ST SUB IN
L
(MONO)
DFX2 SEND
DFX2 SEND
R
24
23
29
P. AMP INPUT
P. AMP INPUT
ST OUT
ST OUT
LAMP
LAMP
(12V/0.5A)
(12V/0.5A)
A
L
B
R
2
2
ST SUB OUT
ST SUB OUT
MONO OUT
MONO OUT
ST SUB IN
ST SUB IN
L
L
(MONO)
PHONES
R
R
25
28
26
1
1
FOOT SW
FOOT SW
27
2
2
FOOT SW
FOOT SW
9
Advertisement
Table of Contents
