Siemens RDH10RF User Manual page 2

Configuration Instructions for the Siemens RF
units
1
Press and release SET button, this
puts the receiver into learn mode
4
To test transmission press TEST on the
transmitter
This will switch relay on in receiver irrespective
of temperature
RF TEST appears in transmitter display. To switch
test off press TEST again
Note: The transmitter and receiver are supplied in a single box already configured. This
procedure only needs to be followed in case of communication issues
2
Press and release LEARN button
on the back of the transmitter
5
Orange LED indicates relay is on
3
Good signal is indicated by the LED
flashing green, then solid
No signal is indicated by the LED
flashing red, then solid
6
Pressing the RESET button for about 4
seconds will erase all ID codes in the
receiver. The set up procedure has to
be repeated to regain communication
PKGPT01027A