Appendix C - SeaPC and SSEnable Software
SeaPC
SeaPC is a PCMCIA Version 2.0 compliant DOS client that will enable
the selected PC Cards I/O address and IRQ when inserted. The SeaPC
driver is located on the supplied diskette in the PCMCIA directory. Please
refer to the README.DOC file for additional information.
Features
•
Allows unique addressing and IRQ selection
•
Provides the highest level of compatibility with installed systems
compliant with PCMCIA standard 2.0 or higher
When should I use the enabler?
This PC Card Client Enabler is not needed in all situations. SeaPC
should be used if one or more of the following conditions occur:
•
The PCMCIA system software (Card and Socket Services) on the host
computer will not configure the cards automatically.
•
The PCMCIA system software on the host computer does not supply a
configuration utility to allow the PC Card to be configured
automatically.
•
The configuration utility with the PCMCIA system software does not
function properly.
SeaPC System Requirements
SeaPC was designed to operate on an IBM PC / AT or compatible
computer. SeaPC requires approximately 3 kilobytes of free conventional
memory. If SeaPC is loaded more than once, an additional 3 kilobytes
plus buffer space is required for each resident copy. SeaPC may be used
with memory managers and loaded into expanded memory. SeaPC
requires MS-DOS or PC-DOS version 3.00 or higher and Card and Socket
Services that are compliant with PCMCIA version 2.00 or higher.
Omega Engineering OMG-P232/P422
Appendix C – SeaPC and SSenable Software
Page 14