Troubleshooting - Casio 130CR Service Manual

7. TROUBLESHOOTING

130CR
1 E01 appears on the display.
2 E94 appears on the display.
3 No date or time on receipt.
Paper is not advancing enough.
4 Drawer opens up after ringing
up only one time.
5 Not clearing totals at end of day
after taking report.
6 Programming is lost whenever
register is unplugged or there is
a power outage.
7 Register is inoperative.
Can't get money out of drawer.
PCR262/CE160
1 E01 appears on the display.
2 E08 appears on the display.
3 E94 appears on the display.
4 No date or time on receipt.
Paper is not advancing enough.
5 Drawer opens up after ringing
up only one time.
6 Not clearing totals at end of day
after taking report.
7 Programming is lost whenever
register is unplugged or there is
a power outage.
8 Register is inoperative.
Can't get money out of drawer.
Symptom/Problem
Symptom/Problem
Most common causes
Changing modes without
completing transaction.
Printer paper is jammed.
Printer is programmed as a
journal.
Department is programmed as
a single item dept.
Using X mode to take out reports.
Bad or no batteries.
No power.
Most common causes
Changing modes without
completing transaction.
Sign on operation is not
perfomed.
Printer paper is jammed.
Printer is programmed as a
journal.
Department is programmed as
a single item dept.
Using X mode to take out reports.
Bad or no batteries.
No power.
— 20 —
Solutions
Return mode switch to
where it stops buzzing and
press .
CA AMT
= TEND
Remove jammed paper.
Turn Mode switch to OFF
then turn to ON, or Turn
power OFF and then turn
power ON.
Program printer to print
receipts.
Program the dept. as a
normal dept.
Use Z mode to take out
reports.
Put in new batteries.
Pull lever underneath
register at rear.
Solutions
Return mode switch to
where it stops buzzing and
press .
CA AMT
= TEND
Prior to starting registration
of any other operation,
press "1" ~ "8" and then
.
CA AMT
= TEND
Remove jammed paper. Turn
Mode switch to OFF then turn
to ON, or Turn power OFF
and then turn power ON.
Program printer to print
receipts.
Program the dept. as a
normal dept.
Use Z mode to take out
reports.
Put in new batteries.
Pull lever underneath
register at rear.