Retaining Bracket; Installing The Diskette Drive - Lenovo ThinkCentre 7096 Hardware Installation Manual

Installing a diskette drive in bay 3
To install a diskette drive in bay 3, do the following:
1. Remove the computer cover. See "Removing the cover" on page 9.
2. Access the system board. See "Accessing system board components and drives"
3. Remove the metal shield from the diskette drive bay by using a flat-blade
4. Remove the plastic panel in the bezel by squeezing the plastic tabs that secure
5. Install a retainer bracket on the side of the diskette drive.
Figure 18. Retaining bracket
6. Install the diskette drive into the bay from the front until it snaps into position.
Figure 19. Installing the diskette drive
7. Align the drive bay assembly with the two slots and rails on the sides of the
on page 10.
screwdriver to gently pry it loose.
the panel on the inside of the bezel.
chassis and connect the flat cable to the new drive.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to Chapter 4, "Completing the parts
replacement," on page 33.
Chapter 3. Installing options and replacing hardware
19