10. See "Closing the cover and connecting the cables" on page 24 to finish the
Removing and replacing a diskette drive
1. Open the cover. See "Opening the cover" on page 12.
2. Slide the lock 1 to the unlocked position.
3. Slide the drive towards the rear of the computer far enough to gain access to
4. Rotate the drive bay assembly upward and remove the diskette drive.
To install a new diskette drive:
1. Slide the new drive partially into the bay from the rear.
2. Connect the flat cable to the new drive.
3. Slide the new drive completely into the bay and slide the lock 1 to the locked
4. See "Closing the cover and connecting the cables" on page 24 to finish the
Installing security features
To help prevent hardware theft and unauthorized access to your computer, several
security lock options are available. The following sections help you identify and
install the various types of locks that might be available for your computer. In
addition to physical locks, unauthorized use of your computer can be prevented by
a software lock that locks the keyboard until a correct password is typed in.
20
User Guide
8. If you are replacing an existing drive, place the master/slave jumper on the
drive in the same position as on the drive being replaced. Also refer to any
instructions that come with the drive.
9. Connect the signal cable and power cable to the drive.
procedure.
the flat cable connector on the drive and disconnect the flat cable from the
drive.
position.
procedure.