Closing The Cover And Connecting The Cables - Lenovo ThinkCentre 8116 User Manual

10. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
11. Reinstall the PCI riser assembly if removed.
12. Close the computer cover and connect the power cord. See "Closing the cover

Closing the cover and connecting the cables

After working with options, you need to install any removed parts, close the
computer cover, and reconnect cables, including telephone lines and power cords.
Also, depending on the option that is installed, you might need to confirm the
updated information in the Setup Utility program.
To close the computer cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Make sure that the cables are routed correctly before lowering the drive bay
3. Lower the drive bay assembly and make sure that the drive locks are both in
4. Close the computer cover.
5. Install any locking devices such as a cable lock as necessary.
6. If your computer is being placed in the vertical position, attach the floor stand.
7. Reconnect the external cables and power cords to the computer. See "Locating
4. Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).
5. Reinstall the PCI riser assembly if removed.
6. Lower the drive bay assembly and reconnect any cables that were
disconnected.
7. Close the computer cover and connect the power cord. See "Closing the cover
and connecting the cables."
8. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
9. Repeat steps 1 through 3 on page 24.
and 2).
and connecting the cables."
or loose screws are left inside your computer.
assembly.
the locked position. Otherwise, you cannot close the computer cover.
connectors on the rear of your computer" on page 8.
Chapter 1. Installing options
25