Toshiba RAS-10SKVP2-E Service Manual page 95

Split type indoor unit high wall, heat pump type outdoor unit heat pump type
Table of Contents

Advertisement

No.
Part name
ˆ
Cross flow fan
<Caution at reassembling>
1) To incorporate the fan motor, remove the fan
Procedures
motor rubber (at shaft core side), incorporate
the motor into the position in the following
figure, and then install the fan motor.
• Install the cross flow fan so that the right
end of the 1st joint from the right of the
cross flow fan is set keeping 70.5 mm from
wall of rear plate of the main unit.
• Holding the set screw, install the cross flow
fan so that U-groove of the fan motor comes
to the mounting hole of the set screw.
• Perform positioning of the fan motor as
follows:
• When assembling the fan motor, the fan
motor must be installed in such a way that
the fan motor leads will be taken out is
positioned at the bottom front.
• After assembling the two hooking claws of
the motor band (right) into the main body,
position the fan motor, insert it, and then
secure the motor band (right) using the two
fixing screws.
U groove
94
FILE NO. SVM-11015
Remarks
5 mm

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents