Detaching And Refitting The Retard Roller - Kyocera FS-2020D Service Manual

(2) Detaching and refitting the retard roller

Procedure
1. Remove the paper cassette.
2. Push the bottom plate down until it locks
(35/37 ppm printer [EUR/USA model] only).
3. Release the two latches and then remove
the retard guide.
4. Remove the retard holder (roller) from the
retard guide.
5. Check or replace the retard roller and refit all
the removed parts.
Paper cassette
Figure 1-5-7
Retard holder
(Retard roller assembly)
Figure 1-5-8
2J0/2J1/2J2
Bottom plate
Latch
Retard guide
Latch
Retard guide
1-5-7