Using The Cr-415 Remote Control - Arcam DV27A Handbook

Using the CR-415 remote control

Dims or turns the player's display on or off.Turning the display off
generally gives a slight improvement in sound quality.
Pressing DISP once turns the display off; twice dims the display.To
restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 16).
Press RPT to cycle through the repeat play options.
Fast play and Skip chapter/tracks
Play fast ( ) and Skip (
'Setup' allows you to configure the DVD player for
use in your system. Ensure that no disc is playing and
press
SETUP
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD)
and menu pages. Confirm your selection with the
Pause ( ), Play ( ) and Stop ( )
These buttons are described on the next page.
OPEN
Opens and closes the disc tray
DISP (display)
a third time.
DISP
A–B
RPT (repeat)
) chapters/tracks in
both directions (see page 6).
SETUP
to access the 'Setup' menu.
button.
OK
Playback control
(see page 6).
Advanced controls
0–9 keypad
This allows direct access to individual tracks on audio CDs.To select
a track, press the corresponding keypad button followed by
tracks greater than 9, enter the digits in sequence. For example, to
play track 15, press
DVD
1 2 3
OPEN
4 5 6
DISP
7 8 9
A–B
0
RPT CLEAR PROG
SETUP MENU
OK
AUDIO TRIM TITLE RTN
ZOOM ANGLE SUBT PL
P
STATUS MEM SRCH
MODE
CR-415
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
14
, then , then .
1 5 OK
Standby
Press to toggle the standby state of the DVD player.
STANDBY
CLEAR
Use within the 'Program' and 'Bookmark' menus to
CLEAR
clear a numeric field (see pages 15–16).
PROG (program)
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
'Programme' menu (see pages 15 and 16).
Page Up/Down (DVD-audio)/Slow play (other discs)
DVD-audio: Some DVD-audio discs allow the user to browse
through images (photographs of the artist, lyrics, etc.) while
music is being played. Use the or
the previous/next page. Note that this is not availble on all
DVD-audio discs.
Other discs: Press or on the remote control to play slow
forward or backwards.There are four speeds of slow playback:
1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle
through the different speeds.To resume normal playback
speed, press .
PLAY
NOTE: Slow play does not apply to audio CDs or DVD-audio
discs.
MENU
Press to access the DVD 'Disc' menu.
MENU
This navigation menu is specific to a disc and varies for each
title, but typically offers facilities to select chapters, languages,
and view extra material such as trailers or documentaries.
Once the menu has been accessed, use the cursor pad to
move around the menu and press
OK
'button'.
MUTE
Stops sound to the speaker outputs of certain Arcam
amplifiers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume ( / ) controls and
+ –
no effect on the audio output level of the DVD players.
. For
OK
PROG to access the
buttons to change to
to activate a menu
button have
MUTE