4. Remove the metal shield from the drive bay by inserting a flat-blade
5. If you are installing any type of drive other than a serial ATA hard disk drive,
6. For a 5.25-inch drive, install a retainer bracket on the side of the drive.
7. For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25 to
18
User Guide
screwdriver into one of the slots and gently prying it loose.
make sure the drive that you are installing is set correctly as either a master or
a slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master
or a slave device.
v If it is the first optical drive, set it as a master device.
v If it is an additional optical drive, set it as a slave device.
v If it is an additional parallel ATA hard disk drive, set it as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
3.5-inch.