Samsung AC018JNHDCH/AA Service Manual page 50

Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and follow the directions below.
1) Press the and buttons at the same time for more than 3 seconds and then a Main menu will be
displayed.
2) Press the / button to select
3) Press the / button to select
code setting screen.
The first digit represents the page number and the remaining five digits are installation option.
NOTE
The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4) Press the / button to set the installation option code in order. Press
page.
SEG1 SEG2
0 2
SEG7 SEG8
1 Drain pump
SEG13 SEG14
External control
2 External control
SEG19 SEG20
Individual control
Heating setting
3 of a remote
controller
SEG8 of the installation option code should be "2" when PCB is changed.
(Since the indoor unit is drained by a drain pump,installation option code setting is needed.)
Samsung Electronics
and then press button to enter a Sub-menu setting screen.
and then press button to enter a Indoor unit installation option
SEG3 SEG4
Exterior
RESERVED temperature
sensor
SEG9 SEG10
Use of Electric
Use of Hot Coil
Heater
SEG15 SEG16
S-Plasma ion
output
SEG21 SEG22
RESERVED
compensation
button to go to the next
SEG5 SEG6
Central control RESERVED
SEG11 SEG12
RESERVED Master / Slave
SEG17 SEG18
Number of hours
Buzzer
using filter
SEG23 -
Away Set OFF
-
Timer
4-15