Table of Contents
Advertisement
KMD-PS971R/X92
4. Press and hold the "FM" or "AM" key for more than 2 seconds so that "TRANSMIT1" is displayed.
5. Point the MASK key canceling remote control toward the light sensor and press for more than 3 seconds
(until the level indicator indicates the full condition).
6. When "TRANSMIT2" is displayed, press and hold the MASK key again for more than 3 seconds. If
"TRANSMIT1" is displayed now, go back to step "5" and restart from there again.
7. When "APPROVED" is displayed, the EEPROM is cleared entirely and the condition in "(11) MASK key
writing procedure (when the EEPROM is in the initial status)" returns.
Item :
Separation
Input Setting :
98.1MHz / 1KHz,
40KHz dev / Pilot:
Output Setting :
Connect a AC voltmeter to speaker output (J1 of X25)
Receiver setting :
FM98.1MHz / Forced narrow of the test mode (It is shown on previous pages)
Alignment Point :
VR1 of X25
Align for :
Adjust so that the crosstalk from Lch to Rch and Rch to Lch becomes minimum.
TEST MODE
ADJUSTMENT (KMD-PS971R only)
6.0KHz dev / Selector: L or R / 60dBµ(ANT input)
8
Advertisement
Table of Contents
