Ordering Parts; Repair Notes - Icom IC-F1010 Service Manual

.:,G
INTRODUCTION
This service manual describes the latest service information for
the lGFl010 VHF PRIVATE MOBILE RADIO and lC-Fl020
VHF LAND MOBILE RADIO at the time of publication.
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
ORDERING PARTS
Be sure to include the following four points when ordering
rep!acement parts:
1 . l Gdigit order numbers
2. Component pad number and name
3. Equipment model name and unit name
4. Quantity required
dAMPLE ORDER>
1110003570 S.lC MC3372 lC-F1010 MAIN UNIT 5 pieces
881 0008660 Screw BT M3 x 8 NI-ZU lGF1010 Bottom cover 10 oieces
Addresses are orovided on the inside back cover for vour
convenience.
DANGER
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than 16 V. This will ruin the
itransceiver.
DO NOT expose the transceiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW) to
the antenna connector. This could damage the transceiver's
front end.
I
REPAIR NOTES
Make sure a problem is internal before disassembling the
transceiver.
DO NOT open the transceiver until the transceiver is
disconnected from its power source.
DO NOT force any of the variable components. Turn them
slowly and smoothly. '
DO NOT shorl any circuits or electronic parts. An insulated
tuning tool MUST be used for all adjustments.
DO NOT keep power ON for a long time when the
transceiver is defective.
DO NOT transmit power into a signal generator or a sweep
generator.
ALWAYS connect a 40 dB to 50 dB attenuator between
the transceiver and a deviation meter or spectrum
analyzer when using such test equipment.
READ the instructions of test equipment thoroughly
before connecting equipment to the transceiver.
a
5.
7.