Nat - TP-Link TD-W8950ND User Manual

TD-W8950ND
address. After the dynamic IPv6 address has expired, the user will be automatically
assigned a new dynamic IPv6 address. The default is 24 hours.
For RADVD:
•
Prefix: Enter a value for the site prefix.
•
Enable MLD Snooping: The modem router can use MLD Snooping to limit the flooding
of IPv6 multicast traffic by dynamically configuring interfaces so that IPv6 multicast traffic
is forwa rded to only those interfaces associated with an IPv6 multicast address.

4.4.5 NAT

NAT (Netw ork Address Translation) allows you to share one WAN (Wide Area Network) IP
address for multiple computers on your LAN (Local Area Network).
Note:
When you select PPPoA or PPPoE for the
type of IPoA and IPoE connection
Web-based Utility (shown in Figure 4-24).
Choose "Advanced Setup" "NAT", there are three submenus under the main menu: Virtual
Servers, Port Triggering, DMZ Host and ALG. Click any of them, and you will be able to
configure the corresponding function.
4.4.5.1 Virtual Servers
Choose "Advanced Setup" "NAT" "Virtual Servers", you can set up virtual servers on the
screen below (shown in Figure 4-25).
Virtual servers can be used for setting up public services on your LAN, such as DNS, Email and
FTP. A virtual server is defined as a service port, and all requests from the Internet to this service
150Mbps Wireless N ADSL2+ Modem Router User Guide
WAN Setup, or when you select Enable NAT for the
(4.4.2 WAN Service), you will see the NAT menu in the
Figure 4-24
34