Edestal Nstallation - Lennox Hearth Products CANYON ST310 Installation And Operation Manual

P i
eDesTal nsTallaTion
(For ash drawer pedestal see instructions included with
pedestal).
Residential and Mobile Homes
(Bolting down and grounding are required only in mobile
homes).
Caution: Wear gloves during installation in case of sharp
edges on the stove.
1. Remove the heater from the carton, if packaged, upon
receipt and check for any damaged or missing parts.
2. Carefully put the stove on pedestal with the open end of
the pedestal facing the rear. DO NOT LEAVE THE STOVE
UNATTENDED UNTIL IT IS BOLTED SECURELY TO THE
PEDESTAL.
3. Line up the holes in the brackets on the pedestal with
the threaded holes in the bottom of the stove. Use the
two 1/2" long bolts and 3/8" standard washers to bolt
the stove to the pedestal. Be sure to see that the stove
is mounted squarely on the pedestal before tightening
the two bolts securely.
4. When installing a pedestal on this stove you MUST plug
the four leg mounting bolt holes, on the bottom of the
stove in the four front corners, with the bolts that were
used to mount the shipping legs. The two rear bolts
should not be installed more the two full rotations to
prevent lifting the bricks off the bottom of the stove.
FAILURE TO INSTALL THESE FOUR BOLTS PROPERLY
WILL RESULT IN REDUCED CONTROL OF THE STOVE'S
COMBUSTION SYSTEM!
5. If required, install the Outside Air Kit (71112) as per the
following instructions. To locate the hole in the hearth
for outside air mark and cut a 4" hole in the hearth. The
hole's center should be 3" directly forward from the
center of the flue outlet or locate as per the instructions
below.
10
6. Position the stove on your floor protection in the ex-
act location where it is to be located, making sure all
minimum clearances are met. Mark the floor protection
where the pedestal will be located, then remove the
stove.
7. Make four 1-1/2" cuts in one end of the corrugated
tube and fold the flaps back. Cut a 4" hole through the
floor protection and the floor, and insert the corrugated
tube into the hole. Cover it with the supplied screen and
fasten it to the floor protector.
8. Locate the 11-1/2"x 14" metal plate and paint to match
the stove if necessary. Position this piece so that the
14" dimension evenly overlaps the lips on the back of
the pedestal (see drawing above). Attach this plate to
the back of the pedestal with the self-tapping screws
supplied.
9. If the stove is to be fastened to the floor, attach the stove
with the supplied lag bolts, through the pedestal base
on opposite sides, attaching them into the floor beneath
the floor protection. Seal any irregularities with silicone
sealer.
10. If installed in a mobile home, the heater shall be
grounded to the chassis with a #8 AGW copper wire or
equivalent.
11. Install bricks as per instructions on page 11. It is highly
recommended that the baffle be assembled before the
chimney is installed so that the ceramic fiber blankets
can be adjusted into place from the flue outlet.
12. Install chimney as per manufacturer's instructions.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.