Yamaha 2004 YP400 Service Manual page 261

3
1
2
1
2
1
3
2
5 - 48
BELT DRIVE
2. Tighten:
• clutch shoe assembly nut 1
NOTE:
_
While holding the clutch shoe assembly with
the rotor holding tool 2, tighten the clutch
shoe assembly nut with the locknut wrench 3.
Rotor holding tool
90890-01235, YU-01235
Locknut wrench
90890-01348, YM-01348
3. Install:
• clutch housing 1
• collar
• secondary sheave nut 2
NOTE:
While holding the clutch housing with the
sheave holder 3, tighten the secondary
sheave nut.
Sheave holder
90890-01701, YS-01880-A
4. Install:
• V-belt
• primary fixed sheave
• collar
• primary sheave nut
NOTE:
• Install the V-belt onto the primary sheave 1
(when the pulley is at its widest position) and
onto the secondary sheave assembly 2
(when the pulley is at its narrowest position),
and make sure the V-belt is tight.
• While holding the primary fixed sheave with
the rotor holding tool, tighten the primary
sheave nut.
Rotor holding tool
90890-01235, YU-01235
ENG
90 Nm (9.0 m · kg, 65 ft · lb)
60 Nm (6.0 m · kg, 43 ft · lb)
83 Nm (8.3 m · kg, 60 ft · lb)