Sharp Aquos LC-60LE660U Operation Manual page 80

Using a PC
Control of the TV (Continue)
Communication procedure
Send the control commands from the PC via the IP.
The TV operates according to the received command and sends a response message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before sending the next command.
Command format
Eight ASCII codes +CR
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0–9, x, blank, ?
Parameter
Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4
values are input for the parameter.)
When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response
code format".)
Any numerical value can replace the "x" on the table.
Response code format
Normal response
Problem response
(communication error or incorrect command)
Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM
POWER ON
COMMAND SETTING
POWER SETTING
INPUT TOGGLE I
SELECTION
TV
1-8
NOTE
If an underbar (_) appears in the parameter column, enter a space.
If an asterisk (*) appears, enter a value in the range indicated in brackets under CONTROL
CONTENTS.
Any numerical value can replace the "x" on the table.
ENG 7-4
COMMAND PARAMETER
R S P W 0 _ _ _ Off
1 _ _ _ On [RS-232C]
2 _ _ _ On [IP]
P O W R 0 _ _ _ Power Off
1 _ _ _ Power On
T G D x _ _ _ (Toggle)
I T V D 0 _ _ _
I A V D * _ _ _ 1: HDMI IN 1,
2: HDMI IN 2,
3: HDMI IN 3,
5:
COMPONENT/VIDEO
IN 2,
6: VIDEO IN 1,
8: PC IN
CONTROL CONTENTS
The Power
On command
rejected.
The Power
On command
accepted.
(For LE661U
model only)
The Power
On command
accepted.
It shifts to
standby.
Power On
It input-
switches by
the toggle. (It
is the same
as an input
change key)
It input-
switches to
TV. (A
channel
remains as it
is. (Last
memory))