RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE HOMEOWNER'S CARE AND OPERATION INSTRUCTIONS MERIT 36" Multi-View Wood Burning Fireplaces P/N 875,040M REV. N/C 01/2007 MODELS CST-38 CPF-38 The information contained in this manual applies to all model fireplaces identified on this page. This information will help you obtain safe and dependable service from your fireplace system.
Wood Fuel Pointers Wood is a wonderful renewable fuel source. Normally it burns clean, leaving only a minimum of waste ash, provides comforting heat and can provide a variety of aromas and visual images. You will want to know which woods are best for use.
Assuming that you are comparing two standard cords of different species but the same volume and moisture content, the denser species will provide more BTU’s. The table of wood species/ densities reveals more helpful guidelines. STARTING A FIRE 1. To start a fire in your fireplace properly, first check the operation of the flue damper.
CAUTION: GLASS AND METAL FRAMES GET HOT — ALWAYS USE HANDLES TO OPEN AND CLOSE THE DOORS. WARNING: CERTAIN MODEL FIRE- PLACES REQUIRE THAT THE GLASS DOORS BE CLOSED DURING OPERA- TION. BE AWARE THAT SAFETY GLASS IS UNPREDICTABLE WHEN HOT AND MAY BREAK, EXPELLING HOT GLASS INTO THE ROOM.
1. Remove the two (2) screws from one of the side lintel extension, leaving the lintel extension on the other side attached to the lintel frame. Only lower the end of the lintel extension closest to the closed end (refractory wall) of the CPF- 38.
If you encounter any problems or have any questions regarding the installation of op- eration of your fireplace system, contact your distributor. For your nearest distributor contact: LENNOX HEARTH PRODUCTS 1110 West Taft Avenue Orange, CA 92865 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE ACCESSORIES AND COMPONENTS...