Lennox Hearth Products EDVI30 Care And Operation Instructions Manual page 12

Carefully install the seven-piece log set into the firebox as shown in
these instructions. All logs should fit onto corresponding pins and/or
log stoppers. This will ensure a proper flame and safe combustion.
1. Place some vermiculite around the burner as shown in Figure 32
(the entire bag of vermiculite will NOT be used).
. Place the Rear Log onto the two corresponding locating pins at
the back of the firebox as shown in Figure 32.
Figure 32
3. Place the Front Right Log and the Center Left Log onto the two
corresponding locating pins (each) as shown in Figure 33.
Center Left Log
Figure 33
4. Place the Front Left Log onto the two corresponding locating pins,
then place the Top Left Log onto the locating pin on the Center Left
Log (the log will rest in the corresponding indent on Rear Log). See
Figure 34.
Figure 34
1
Rear Log
Vermiculite
Front Right Log
Top Left Log
Front Left Log
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
5. Place the Front Center Log in place as shown in Figure 35. The
back of the log fits into the corresponding indent on Rear Log.
Figure 35
6. Install the Top Right Log into the corresponding indentations on
Front Center Log and Front Right Log as shown in Figure 36.
Figure 36
7. Place the glowing embers on the burner as shown in Figure 37.
One package of ember material has been included with this log set
You will not need to use the entire bag.
IMPORTANT: The quantity and placement of the ember material can
affect insert performance, therefore, it is very important that it be
Figure 37
placed as shown in
a. Unpackage and divide the fine ember material (mineral wool) into
dime-sized fluffy pieces.
b. Distribute the pieces over the top of the front burner area in front of
Figure 37
the forward logs (see
Figure 37
Front Center Log
Top Right Log
.
).
Embers