Troubleshooting - Samsung SafeVIEW SEW-3037W User Manual

Troubleshooting

Problem
No picture from a 1. Check all connections to the camera. Make sure the adapter is plugged in.
camera 2. Make sure that the cameras and monitor are both ON.
3. Make sure that the camera is in range of the monitor.
4. Make sure the camera and monitor are paired.
5. Adjust the monitor antenna to vertical position.
The picture is or has The picture may become choppy when experiencing a lower frame rate
become choppy (i.e. 10 frames per second vs. a higher 20 frames per second).
1. Try moving the camera closer to the monitor.
2. Remove obstructions between the monitor and camera.
3. Adjust the monitor antenna to vertical position.
No sounds (even with 1. Make sure that the power adapter is connected to the camera.
both units turned on) 2. The battery on the monitor may be dead, be sure to charge it using the
adapter included.
3. The monitor may be out of range of the camera; be sure to check if the
Range LED in on continuously.
Your SafeView is
emitting an high This sound is normal feedback which occurs if the monitor and camera are too
pitched noise/ close together. Move them further apart.
feedback.
Low batteries will cause the supply current to become unstable and will affect the quality
`
n
of the video/audio. Please charge the battery fully for use for superior video.
SEW-3037W-ENGLISH.indd 15
Solution
English · 15
2012-09-03 오전 11:37:21