Problems With The Projector - Acer X111 Series User Manual

9
10
11

Problems with the Projector

#
1
2
Downloaded From projector-manual.com Acer Manuals
Image is too small •
or too large
•
•
Image has slanted •
sides
•
•
Image is reversed •
Condition
The projector stops responding
to all controls
Lamp burns out or makes a
popping sound
Adjust the zoom lever on the top of the projector.
Move the projector closer to or further from the
screen.
Press "MENU" on the control panel or remote
control. Go to "Image" > "Aspect Ratio" and try
different settings.
If possible, reposition the projector so that it is
centered on the screen and below the bottom of the
screen.
Press the Keystone correction keys on the control
panel or remote control until the image becomes
square.
Press "MENU" on the control panel or remote
control to open the OSD menu. Go to "Image" >
"Auto Keystone (X1140A/X1240/X1340W/P1340W)"
or "Image" > "Keystone (X111/X1140/H6510BD)" to
make adjustments.
Select "Image" > "Projection Mode (X1140A/X1240/
X1340W/P1340W)", "Image" > "Projection Location
(X1140A/X1240/X1340W/P1340W)" on the OSD and
adjust the projection direction.
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow
the procedures in the "Replacing the Lamp"
section.
Solution
41