Smartrunk Ii; Operation; Basic Operation - Icom iC-F30GT Instruction Manual

SmarTrunk II

' ' Basic operation

These features are enabled by your Dealer or System operator and
may not be available in your system. Contact your Dealer for details.
Push the [Bank] switch one or more times to select a channel bank
for conventional channels or SmarTrunk II™ channels.
• Scanning starts when a channel bank for SmarTrunk II
D D PTT dispatch operation*
q Push [PTT] once
w Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
e Receiving a dispatch call is indicated by the same three-beep
sequence.
• It is not necessary to push [M] to answer a dispatch call.
D D System busy indication
If all channels are busy, three low beeps sound after you initiate
a call. Try the call again later.
D D Receiving a subscriber-to-subscriber call*
When you hear ringing, push [M] to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.
D D Receiving a landline-to-subscriber call*
When you hear ringing, push [M] to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.
D D Terminating a call*
After completing a call, push [#] to disconnect (hang up).
IMPORTANT: If one person in the conversation terminates a call,
TM
1
(without dialling)
1
all participants will be cut off.

OPERATION

to initiate a dispatch call.
1
6
TM is selected.
1
19