Chassis Removal - Sanyo LCD-27XA2 Service Manual

Mechanical Disassembly

3. Chassis Removal

After removing Cabinet Back and Stand, remove 8 screws of Chassis base, remove 2 screws of ASSY, PWB,
CONTROL, disconnect each connectors and the chassis can be taken out.
Speaker
ASSY, PWB, POWER
ASSY, PWB, CONTROL
How to Remove Flat Cable
There are following kinds of the connectors of flat cable. Be careful not to damage a connector in the case of removal of
a flat cable or attachment.
Type-A
Cable
Type-B
Cable
Fan Motor
ASSY, PWB, SCAL
For removal of flat cable, lift up the
hook of both sides.
For insert and fixing, hold down the
hook after inserting the flat cable.
For removal of flat cable, slide the
hook of both sides.
For insert and fixing, slide the hook
to previous position after inserting
the flat cable.
Chassis Base
ASSY, PWB, SIGNAL
Type-C
For removal of flat cable, pull off only.
For fixing, insert into the socket.
Cable
Type-D
-14-
For removal of flat cable, hold down
the hook.
For insert and fixing, lift up the hook
after inserting the flat cable.
Speaker