Care and Cleaning
Titanium apatite photocatalytic air-purifying fi lter
1.
Take off the titanium
apatite photocatalytic air-
purifying fi lter.
•
Open the front panel and pull out the air fi lters.
•
Hold the recessed parts of the frame and unhook
the 4 claws.
Claw
Claw
2.
Clean or replace the titanium
apatite photocatalytic air-
purifying fi lter.
[Maintenance]
2-1
Vacuum dusts, and soak in cold
water (avoid using warm or hot
water).
10 to 15 minutes if dirt is heavy.
•
Do not remove the fi lter from frame when
washing with water.
2-2
After washing, shake off remaining
water and dry in the shade.
•
Since the material is made out of polyester, do
not wring out the fi lter when removing water from
it.
33
01_EN_3P255639-2A.indd 33
[Replacement]
Remove the filter from the filter
frame and attach a new one.
•
Do not throw away the fi lter frame. Reuse the
filter frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
•
Dispose of the old filter as non- flammable waste.
3.
Set the fi lters as they were
and close the front panel.
•
Press the front panel at both sides, and then pull
down to close the front panel.
NOTE
•
Operation with dirty fi lters:
–
cannot deodorize the air,
–
cannot clean the air,
–
results in poor heating or cooling,
–
may cause odour.
•
Dispose of old fi lters as non-fl ammable waste.
•
To order titanium apatite photocatalytic air-purifying
lter contact to the service shop there you bought the
air conditioner.
Titanium apatite photocatalytic
Item
air-purifying fi lter (without frame) 1 set
Part No.
KAF970A46
2/16/2011 2:44:15 PM