Checking And Cleaning Air Intake Screen; Checking Tire Pressure; Inflation Pressure - Kubota ZG124E-AU Operator's Manual

34 PERIODIC SERVICE
BChecking and Cleaning Air Intake Screen
To avoid personal injury:
A Be sure to stop the engine and remove the key
before cleaning.
A Make sure that the engine is cool to the touch
before cleaning.
A The air intake screen and air intake area must be clear
of debris to prevent the engine from overheating.
Daily or after every 5 hours of operation, check to be sure
the air intake screen and the air intake area are clean.
Dirt or chaff around the air intake screen and air intake
area or the engine cooling area decrease cooling
performance.
1. Check that the air intake screens are clear of grass
clippings and debris.
2. If screens are dirty, clean screens with a brush or
cloth.
3. Remove the dust and all foreign material from the
engine plate.
(1) Air intake screen
(2) Engine plate
BChecking Tire Pressure
To avoid serious injury:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Inflation pressure in front tires rises quickly
when using compressed air.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Do not use tires larger than specified.
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
Tire sizes
11 x 4 - 5,
Front
4PR Smooth
22 x 10 - 14,
Rear
4PR Turf
(1) Ground
Recommended Inflation
Max. Pressure
170 kPa
(1.7 kgf/cm )
110 kPa
(1.1 kgf/cm )
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"