Connections; Descriptions Of Terminals; Basic Style - Pioneer PLX-1000 Operating Instructions Manual

Connections

! Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
! Refer to the operating instructions for the component to be connected.
! Connect the power cord after all the connections between devices have been completed.

Descriptions of terminals

1 PHONO OUT terminals
Connect the audio cables (included) here.
2 SIGNAL GND terminal
Connect the ground wire (accessory). This helps reduce noise when
connecting an analog player.

Basic style

! Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the
power cord.
! Refer to the operating instructions for the component to be connected.
Connecting to a pre-main amplifier and component
Pre-main amplifier, components, etc.
1 Connect the audio cable and ground wire to the [PHONO] input terminal of the pre-main amplifier or other
component.
! If this product is connected to a pre-main amplifier or component that does not have a [PHONO] terminal, sufficient volume and sound quality
cannot be obtained. In this case, use the PHONO equalizer.
! Make sure to connect the ground wire. If the unit is not properly grounded, a power hum (humming sound) occurs.
2 Connect the power cord.
Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the
power cord.
! Before connecting to the outlet (AC outlet) mounted on the connected equipment, check the wattage displayed on the outlet. (This unit con-
sumes 9 W of power.)
1 2
3 AC IN
Ground wire
Audio cable
3
Connects to a power outlet using the included power cord. Wait until
all connections between the equipment are completed before con-
necting the power cord.
! Be sure to use the included power cord.
L
R
Power cord
Rear panel
To power outlet
En
13