[Video Setup] Screen - Sony AWS-750 Operating Instructions Manual

• [Read-write Community]: Enter the read-write
community name.
[Communication Hosts]: Specify the IP address of the
SNMP manager.You can specify up to two.
• [IP Address 1] and [IP Address 2]: Enter the IP
address or network address. Use periods (.) as
separators when entering the settings.
[Apply]: Apply the settings.
Tip
If further information is required, contact your local Sony
representative.

[Video Setup] Screen

Configure video input and output settings and video
signal settings.
The following items are available in the [Video Setup]
settings.
Item Description
Input Configure settings related to
video inputs.
System Configure settings related to
video signals for the system as
a whole.
Output Configure settings related to
video outputs.
System Configure the system timecode. page 99
Time Code
[Input]
Configure settings related to video inputs.
Configure each setting after selecting a video input
connector.
Video input connectors
[Input 1] to [Input 6]: Select the video input.
[Name]: Enter up to 20 alphanumeric characters for the
video input name.
The name configured here will appear in the various
lists in the main screen.
[Connector]: For [Input 1] to [Input 4], select the video
input connector to assign to each video input number.
• For [Input 1] and [Input 3]: Select [SDI] or
[Composite].
• For [Input 2] and [Input 4]: Select [RGB] or
[HDMI].
Tip
[Input 5] and [Input 6] are fixed at SDI.
[SD Input Aspect]: Select the aspect ratio for SD input
signals.
• [4:3 (Center)]: Center the 4:3 aspect ratio (i.e.,
fitted to the top and bottom of the display with black
bars on the left and right).
• [16:9 (Wide Zoom)]: Stretch the aspect ratio to
16:9 (i.e., fitted to the left and right of the display).
Reference
page 97
page 26
[Video Format]: Select the signal format that will be
page 98
input to each video input connector.
page 98
Tip
When [Auto] is selected for RGB or HDMI, the
optimal signal is determined between the unit and
input source device, and the video will be displayed
at that resolution.
[Embedded Audio]: Specify the input channels of the
embedded audio to be used.
• [1/2Ch]: Use channel 1 and 2 of the embedded
audio.
• [3/4Ch]: Use channel 3 and 4 of the embedded
audio.
Tip
Depending on the video input connector, some
options may not be available.
• For HDMI, the setting is fixed at [1/2Ch].
• For composite and RGB, this setting is disabled due
to the lack of embedded audio.
[Remote Control]: Configure control settings for remote
cameras.
• [Off]: Disable remote control.
• [VISCA 1] to [VISCA 7]: Select the address of the
remote camera to be controlled.
For details on remote camera settings, see "Remote
Camera Connections and Settings" (page 93).
Configuring System Settings ([System Setup] menu)
97