Download Print this page

Lanier 117-0163 Material Safety Data Sheet

T6450 black toner for lanier 6450, 6550

Advertisement

Quick Links

MATERIAL SAFETY DATA SHEET

Emergency Telephone: 800-551-3087
Identity:
T6450 Black Toner
Product ID:
117-0163
Synonyms
& Common
Toner, Black
Names:
Uses:
Lanier 6450, 6550
Chemical
Formula:
Mixture
Styrene acrylate copolymer
Carbon black
Polypropylene
Organic pigment
*PEL as the product: 15mg/m
*TLV as the product: 10mg/m
HMIS Rating:
FLAMMABILITY = 1
REACTIVITY = 0
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure
to any non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): Prolonged inhalation of excessive dust may cause lung damage. It is
attributed to "lung overloading", a generic response to excessive amounts of any dust retained in the lungs for a prolonged interval.
Use of this product, as intended, does not result in inhalation of excessive dust.
Carcinogenicity: Carbon Black was reclassified as a Group 2B by the IARC in 1996 based upon the result of only the inhalation
study in rats. However, there was not observed the incidence of tumors on the test results on dermal or oral studies. Also, 2-years
inhalation study using a typical toner containing carbon black showed no association between toner exposure and animal tumors.
Gargle with water. Remove to fresh air if effects
occur. Get medical attention if needed.
Inhalation:
Wash with soap and water.
Skin Contact:
Suitable extinguishing media: CO , dry chemical, foam or water.
Fire Fighting Instructions: Generally by sprinkling or extinguisher
Special protective equipment for fire fighters: none
UEL: n/a
Burning rate: N/a
y o u r d o c u m e n t m a n a g e m e n t p a r t n e r
Section 1: Chemical Product and Company Information
Section 2: Composition / Information on Ingredients
PERCENT
88.5
6.5
3.5
1.5
3
3
(total dust), 5mg/m
(respirable dust)
3
3
(total dust), 5mg/m
(respirable dust)
Section 3: Hazards Identification
HEALTH = 1
Section 4: First Aid Measures
Section 5: Fire Fighting Measures
2
LEL: n/a
MSDS No.
Issued:
Supersedes:
Date:
Prepared by:
Approved by:
CAS No.
27136-15-8
1333-86-4
25085-53-4
115706-73-5
SPECIAL = none
Eye Contact:
Ingestion:
Lanier Worldwide, Inc.
2300 Parklake Drive, NE
Atlanta, GA USA 30345-2979
CP- 269
05/01/2006
03/10/2003
05/01/2006
EH&S Department 770-496-9500
Larry Choskey, Manager, CEH&S
EXPOSURE LIMITS
Not listed
3
3.5 mg/m
3
3.5 mg/m
Not listed
Not listed
In case of contact, immediately flush eyes
with water for 15 minutes. Get medical
attention if needed.
Dilute stomach contents with several
glasses of water. Get medical attention.
SOURCE
N/a
OSHA TWA
ACGIH TWA
N/a
N/a

Advertisement

loading

Summary of Contents for Lanier 117-0163

  • Page 1: Material Safety Data Sheet

    Identity: T6450 Black Toner Product ID: 117-0163 Synonyms & Common Toner, Black Names: Uses: Lanier 6450, 6550 Chemical Formula: Mixture Section 2: Composition / Information on Ingredients Styrene acrylate copolymer Carbon black Polypropylene Organic pigment *PEL as the product: 15mg/m...
  • Page 2 Page 2 of 3 CP-269 Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury.
  • Page 3 Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its use.