Table of Contents
Advertisement
3-6. The adjustment item which in necessary in part exchange
COMPL PWB CP1
COMPL PWB ST1
COMPL PWB ST2
ASSY FPC, CA1
LENS
: Be sure to carry out the necessary adjustments after replacing the unit.
: Adjustment is possible from the menu setting screen of the camera and by using the calibration software.
3-7. Updating the firmware
Check the firmware version immediately after the CP1 board has been replaced. If an old version is being used, interfer-
ence and errors in operation may also occur. If an old version is being used, update it with a newer version.
3-13. Firmware uploading procedure. (Page 18)
Refer to
3-8. Adjust Specifications
1. Lens Adjustment (Infinity)
Camera
Preparation:
POWER switch: ON
If using a ready-made collimator, set to infinity.
Note:
Do not vibrate during the adjustment.
Adjustment method:
1. Set a distance of 0.5-1.0 cm between camera lens and
collimator lens when zoom wide edge. Do not touch the
each lens.
2. Set the camera so that it becomes center of the siemens
star chart in the collimator (zoom wide and tele).
Lens
AWB
Adjust-
Adjust-
ment
ment
(Infinity)
Collimator
CCD Black
CCD White
Point And
Point
White Point
Defect
Defect Detect
Detect
Adjustment
Adjustment
In Lighted
3. Double-click on the DscCalDi.exe.
4. Click the "Focus", and click the "Yes".
5. Lens infinity adjustment value will appear on the screen.
6. Click the OK.
DscCalDi
!
Adjustment value determination is effectuated using below val-
ues.
The adjustment values fulfill the conditions below, they are de-
termined as within specifications.
Adjustment value determination
PZ_SW_A_B: PZ1
PZ1: adjustment value of zoom PR switch position 1
(945<=PZ1+PBR<=1010)
– 15 –
USB
Factory
Language
storage
Cord
Setting
information
Setting
registration
x
Focus Result
PZ_SW_A_B: 956
PZ_SW_B_C: 1058
PZ_SW_C_B: 1037
PZ_BR: 17
PZ_SP: 266
AF_SW: 941
AF_BR: 6
AF_WIDE: 1
AF_MID1: -19
AF_MID2: -37
AF_MID3: -36
AF_TELE: -33
OK
Reset
Setting
Advertisement
Chapters
Table of Contents
